Skip to main content

Attaching the VP-3350 and Bracket to the 15" NX Restaurant Station (Nexus)

Updated

 

 

1. Unpacking Components

  • Carefully remove the VP-3350 and Nexus bracket from their packaging.

  • Check the Nexus bracket package for the following:

    • Two small silver screws (in the blue packaging with the interface cable).

    • Two black screws (used for attaching the bracket to the terminal).

  • Verify that all components listed in the manual are present before proceeding.

2. Disassembling the Nexus Bracket

  • Unscrew all screws attached to the Nexus bracket:

    • Six short screws (four on the back and two on the sides), each with a nylon washer.

    • Two longer screws used to secure the front part of the bracket.

  • Separate the bracket into three parts:

    • Back plate and cover.

    • Main bracket assembly.

    • Front fascia cover.

  • Take note of the orientation and placement of each piece for reassembly later.

3. Preparing the VP-3350 Interface Cable

  • Identify the components of the interface cable:

    • USB-C to five-pin interface.

    • Grounding cable from the five-pin to Nexus four-pin interface.

  • Gently pull apart the two cable sections for separation.

  • Inspect the connectors to ensure there is no damage before assembly.

4. Attaching the USB-C Cable to the VP-3350

  • Connect the USB-C cable to the VP-3350:

    • Ensure the right angle of the cable points toward the back of the device.

  • Pass the cable through the hole on the VP-3350 bracket.

    • Leave enough cable length for proper connection.

  • Confirm the cable is securely connected and seated properly in the port.

5. Securing the VP-3350 to the Bracket

  • Align the VP-3350 with the main bracket assembly.

  • Use the two small silver screws to attach the VP-3350 securely to the bracket.

  • Tighten the screws carefully to avoid stripping or over-tightening.

6. Attaching the Bracket to the Terminal

  • Position the Nexus bracket on the terminal.

  • Use the two black screws to secure the bracket to the terminal.

  • Ensure the bracket is firmly attached and does not shift during operation.

7. Final Assembly

  • Reattach the back plate and cover to the bracket.

  • Double-check the alignment of all components before tightening screws.

  • Secure all screws, ensuring they are tightened without over-tightening.

8. Testing the Installation

  • Power on the terminal and test the VP-3350 to ensure it is functioning correctly.

    • Swipe a test card to confirm the reader is operational.

  • Verify the stability of the bracket and cable connections by gently testing for movement.

  • Inspect all visible components to ensure proper assembly.

This guide outlines the critical steps for configuring and attaching the VP-3350 and Nexus bracket. For further assistance please contact our support team.

 

Related articles

Powered by Zendesk